I. Equipment Operation Process

Turn on the power switch.

Press the start button to bring the equipment to standby mode.

Place the bag at the bag loading port located on the conveyor belt, allowing it to enter the equipment automatically.

The equipment automatically opens the bag and empties the material inside.

After completing one bag, proceed to place the next bag. Repeat this process until all unpacking tasks are completed.

Press the stop button to end equipment operation, then turn off the power switch.

II. Equipment Maintenance Steps
To ensure the effective service life of the unpacking machine, regular maintenance must be performed. The maintenance steps are as follows:

After each operation, clean the equipment and remove any residual material to avoid affecting subsequent operations.

During daily use, regularly inspect all parts of the equipment to ensure it is in proper working condition. Report any abnormalities to maintenance personnel promptly.

Lubricate the equipment to ensure all parts maintain good friction conditions, thereby extending its service life.

Conduct safety inspections of the equipment, checking whether all parts are functioning properly, and make appropriate marks and records.

III. Safe Operation Guidelines
The unpacking machine is an important piece of production equipment. The following safe operation guidelines must be followed during use:

Before operating the equipment, wear appropriate work attire, gloves, masks, and other protective gear.

Operate the equipment with standardized actions, following the operational procedures and logs.

Before using the unpacking machine, conduct a safety inspection to ensure all parts are functioning properly for safe use.

If the equipment malfunctions or experiences abnormalities, stop using it immediately and notify relevant personnel for handling.

Unauthorized personnel are prohibited from entering the equipment operation area.

IV. Common Faults and Emergency Measures
During the use of the unpacking machine, some faults or unexpected situations may occur. The following are common faults and corresponding measures:

Equipment Not Working
(1) Check if the power supply is normal.
(2) Check if the control system is functioning properly.
(3) Check if the equipment sensors are working correctly.

Sudden Shutdown
(1) Check if the equipment is overloaded.
(2) Check if there are any abnormal or unusual noises.

Bag Jamming
(1) Check if the conveyor belt is operating normally.
(2) Check if the bag is placed correctly.
(3) Check the tension of the conveyor belt.